Marcy NS-1104U Owner's Manual page 8

STEP-2
A.) NOTE: Extra help may be needed to hold the Front Post (#2) while connecting the cables and
wires.
B.) Remove the four pre-assembled M8 x ¾" Allen Bolt (#20), four Ø ⅝" Lock Washers (#28), and four
Ø ⅜" x Ø ¾" Curved Washers (#15) from the Front Post (#2).
C.) Insert the Front post through the Front Post Cover (#9) and attach to the Main Frame (#1).
D.) Connect the Upper Computer Wire (#24) from bottom of Front Post to the Lower Computer Wire
(#22) from the Main Frame.
E.) Pull the tension connector from the Upper Tension Cable (#27) and slide in between the opening on
the connector on the Lower Tension Cable (#19). Pull the Upper Tension Cable upward and slide
the wire through the slot on the bracket.
F.) Drop down the Upper Tension Cable so the fitting sits firmly on top of the bracket.
G.) Secure the Front Post to the Main Frame with four M8 x ¾" Allen Bolt (#20), four Ø ⅝" Lock
Washers (#28), and four Ø ⅜" x Ø ¾" Curved Washers (#15).
©IMPEX INC.
7
www.marcypro.com