Checking Drive Belts - Hyundai H-100 Owner's Manual

G170A01A-GAT
BRAKE PEDAL
3 ~ 8 mm
(0.12 ~ 0.31 in.)
G160A01HR
With the engine off, press down on the
brake pedal several times to reduce the
vacuum in the brake booster.
Then, using your hand, press down
slowly on the brake pedal until you feel
a change in resistance. This is the
brake pedal free-play.
The free-play should be within the limits
specified in the illustration. If it is not,
have it inspected by your Hyundai
dealer and adjusted or repaired if nec-
essary.

CHECKING DRIVE BELTS

G190A01HR-GAT
Power steering pulley
1
Water pump pulley
Tension pulley
3
2
Generator
COMP. pulley
pulley Crankshaft pulley
G190A01HR
Drive belts should be checked periodi-
cally for proper tension and adjusted if
necessary.
Belt Proper tension
1 7 ~ 10 mm
a new belt
9 ~ 12 mm
2
a used belt
11 ~ 14 mm
3 7 ~ 10 mm
At the same time, belts should be
examined for cracks, wear, fraying or
other evidence of deterioration and re-
placed if necessary.
DO-IT-YOURSELF MAINTENANCE
Belt routing should also be checked to
be sure there is no interference be-
tween the belts and other parts of the
engine. After a belt is replaced, the new
belt should be adjusted again after two
or three weeks to eliminate slack result-
ing from initial stretching after use.
!
WARNING:
The drive belt should be checked
when the engine is cool or cold to
avoid burning yourself on hot en-
gine.
6
21