Hyundai H-100 Owner's Manual page 91

K240B01HR-GAT
1. POWER ON-OFF Control
Knob
The radio unit may be operated when
the ignition key is in the "ACC" or "ON"
position. Press the knob to switch the
power on. The LCD shows the radio
frequency in the radio mode or the tape
direction indicator in the tape mode. To
switch the power off, press the knob
again.
VOLUME Control
Rotate the knob clockwise to increase
the volume and turn the knob counter-
clockwise to reduce the volume.
2. BAND Selector
Pressing the button changes the
FM/AM
AM, FM1 and FM2 bands. The mode
selected is displayed on LCD.
Each press of button changes the dis-
play as follows;
FM1 → FM2 → AM → FM1
3. LCD
LCD shows the following informations;
Band of FM1/FM2/AM frequency, pre-
set channel number, ST in case of FM
stereo.
4. TREB (Treble) Control Knob
Press to pop the knob out and turn to
the left or right for the desired treble
tone.
5. TUNE (Manual) Select Button
Press the ( ) side or ( ) side to increase
or to decrease the frequency. Press
either button and hold down to continu-
ously scroll. Release button once the
desired station is reached.
SEEK Operation
(Automatic Channel Selection)
Press the TUNE select button 0.5 sec
or more. Releasing it will automatically
tune to the next available station with a
beep sound.
FEATURES OF YOUR HYUNDAI
When the ( ) side is pressed longer than
0.5 second, releasing will automatically
tune to the next higher frequency and
when the ( ) side is pressed longer than
0.5 second and releasing will automati-
cally tune to the next lower frequency.
6. PRESET STATION Select But-
tons
Six (6) stations for AM, FM1 and FM2
respectively can be preset in the elec-
tronic memory circuit on this unit.
HOW TO PRESET STATIONS
Six AM and twelve FM stations may be
programmed into the memory of the
radio. Then, by simply pressing the
band select button and/or one of the six
station select buttons, you may recall
any of these stations instantly. To pro-
gram the stations, follow these steps:
o Press band selector to set the band
for AM, FM1, or FM2.
o Select the desired station to be stored
by seek or manual tuning.
o Determine the preset station select
button you wish to use to access that
station.
1
79