Checking The Brakes - Hyundai H-100 Owner's Manual

Park the car on level ground with the
engine off.
1. Using a wrench of the correct size,
loosen the oil filler plug by turning it
counterclockwise and remove it with
your fingers.
2. Use a suitable tool to feel inside the
hole. The oil level should be within 14
mm from its bottom edge. If it is not,
check for leaks before adding oil. To
refill the rear axle or bring the oil level
up,add oil slowly until it reaches the
proper level. Do not overfill.
3. Replace the plug and washer, screw
it in with your fingers and then tighten
securely with the wrench.
NOTE:
It is recommended that the rear axle
oil should be checked by an autho-
rized Hyundai dealer.

CHECKING THE BRAKES

G120A01A-AAT
!
CAUTION:
Because brakes are essential to the
safe operation of the car, it is sug-
gested that they be checked and
inspected by your Hyundai dealer.
The brakes should be checked and
inspected for wear at those inter-
vals specified in the vehicle mainte-
nance schedule in Section 5.
G120B01A-AAT
Checking the Brake Fluid Level
!
WARNING:
Use caution when handling brake
fluid. It can damage your vision if it
gets into your eyes. It will also dam-
age your vehicle's paint if spilled
on it and not removed immediately.
DO-IT-YOURSELF MAINTENANCE
G120C02A-AAT
Recommended Brake Fluid
Use only hydraulic brake fluid con-
forming to DOT 3 or DOT 4 specifica-
tions in your braking system. Follow
the instructions printed on the con-
tainer.
G120D01A-AAT
To Check the Fluid Level
Left-hand Drive type
HHR5015
6
17