Hyundai H-100 Owner's Manual page 180

NOTE:
It is recommended that water accu-
mulated in the fuel filter should be
removed by an authorized Hyundai
dealer.
!
WARNING:
o Do not smoke or have any other
open flame near the vehicle while
bleeding the fuel system.
o Be sure to carefully wipe away any
water drained out in this manner,
because the fuel mixed in the wa-
ter might be ignited and result in a
fire.
HEADLIGHT AIMING
ADJUSTMENT
G290A01FC-GAT
Before performing aiming adjustment,
make sure of the following.
1. Keep all tires inflated to the correct
pressure.
2. Place the vehicle on level ground
and press the front bumper and rear
bumper down several times. Place
the vehicle at a distance of 3,000
mm (118 in.) from the test wall.
3. See that the vehicle is unloaded
(except for full levels of coolant,
engine oil and fuel, and spare tire,
jack, and tools).
4. Clean the head lights lens and turn
on the headlight (low beam).
5. Open the hood.
6. Draw the vertical line (through the
center of each headlight beam pat-
tern) and the horizontal line (through
the center of each headlight beam
pattern) on the aiming screen.
And then, draw a horizontal parallel
line at 30 mm (1.18 in.) under the
horizontal line.
DO-IT-YOURSELF MAINTENANCE
Vertical aiming
Horizontal
aiming
G290A01HR
7. Adjust each cut-off line of the low
beam to the parallel line with a phillips
screwdriver - VERTICAL AIMING.
8. Adjust each cut-off line of the low
beam to each vertical line with a
phillips screwdriver - HORIZONTAL
AIMING.
6
29