Hyundai H-100 Owner's Manual page 149

5
VEHICLE MAINTENANCE REQUIREMENTS
10
F060F01A-AAT
o Vacuum and Crankcase
Ventilation Hoses
Inspect the surface of hoses for evi-
dence of heat and/or mechanical dam-
age. Hard and brittle rubber, cracking,
tears, cuts, abrasions, and excessive
swelling indicate deterioration. Particu-
lar attention should be paid to examin-
ing those hose surfaces nearest to
high heat sources, such as the ex-
haust manifold.
Inspect the hose routing to assure that
the hoses do not come in contact with
any heat source, sharp edges or mov-
ing component which might cause heat
damage or mechanical wear. Inspect
all hose connections, such as clamps
and couplings, to make sure they are
secure, and that no leaks are present.
Hoses should be replaced immedi-
ately if there is any evidence of dete-
rioration or damage.
F060G01A-AAT
o Vapor Hose and Fuel Filler Cap
The vapor hose and fuel filler cap
should be inspected at those intervals
specified in the maintenance sched-
ule. Make sure that a new vapor hose
or fuel filler cap is correctly replaced.
F060H01A-AAT
o Air Cleaner Filter
A Genuine Hyundai air cleaner filter is
recommended when the filter is re-
placed.
F070B01A-GAT
o Cooling System
Check the cooling system part, such
as radiator, coolant reservoir, hoses
and connections for leakage and dam-
age. Replace any damaged parts.
F070C01A-AAT
o Coolant
The coolant should be changed at
the intervals specified in the mainte-
nance schedule.
F060B01HR-GAT
o Drive Belts
Inspect all drive belts (water pump and
alternator) for evidence of cuts, cracks,
excessive wear or oiliness, and re-
place if necessary. Drive belts should
be checked periodically for proper ten-
sion and adjusted as necessary.
F060E01A-GAT
o Timing Belt
Inspect all parts related with the timing
belt for damage and deformation. Re-
place any damaged parts immediately.
F070D01HP-GAT
o Manual Transmission Oil
Inspect the manual transmission oil
according to the maintenance sched-
ule.
NOTE:
If the oil level is low, check for
possible leaks before adding oil.
Do not overfill.