Labeling The Module I/O - Siemens Simatic S7-300 CPU 31xC Series Installation And Operating Instructions Manual

6.7

Labeling the module I/O

Introduction
The labeling strips are used to document the assignment of module I/Os and the sensors /
actuators of your system.
You have to use the following labeling strips, depending on the module:
Table 6-8
Module
SMs (not 32-channel),
FMs,
Communication module CP 342-2
SMs (32-channel)
Labeling strips Labeling and inserting
1. Label the strips with the addresses of the sensors / actuators.
2. Slide the labeled strips into the front panel.
P S
Hint
Templates for labeling strips are available on the Internet at http://www.ad.siemens.de/csinfo
article ID 11978022.
S7-300, CPU 31xC and CPU 31x: Installation
Operating Instructions, Edition 08/2004, A5E00105492-05
Labeling strip assignment to modules
C P U
6.7 Labeling the module I/O
Labeling strip
order no.:
6ES7 392-2XX00-0AA0
6ES7 392-2XX10-0AA0
Wiring
6-11