Download Print this page

Dell EMC N20 Series Manual page 8

Dell networking os conversion guide for the n20xx/n30xx series

Advertisement

Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
If you are using Dell Networking OS 6.3.1.x:
console#copy ftp://username@10.16.127.36/NSeriesRANsw.tgz application
Remote Password:********
Transfer Mode.................................. FTP
Server IP Address.............................. 10.16.127.36
Source File Path............................... ./
Source Filename................................ NSeriesRANsw.tgz
Data Type...................................... Application
Downloads application file
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
NOTE:
Because Dell Networking OS version 6.3.x.x does not support copying files larger than 32MB using TFTP, use
file transfer protocol (FTP).
2
Install the NSeriesRANsw application.
console(config)#application install NSeriesRANsw
The following command output shows the installed applications:
console(config)#do show application
OpEN application table contains 3 entries.
Name
---------------- ----------- ----------- ----------- ----------
SupportAssist
hiveagent
NSeriesRANsw
console(config)#exit
console#
3
Start the NSeriesRANsw application
CAUTION:
Do not power cycle the system after you start the NSeriesRANsw application.
console#application start NSeriesRANsw
Application started.
After you start the NSeriesRANsw application, the system restarts and launches a series of conversion procedures that eventually installs
Dell Networking OS Version 9.11.x.x on the system. Some of the conversion procedures may take several minutes to complete. Please do
not power cycle the system when the conversion procedures are in progress. After successful installation, the system boots into Dell
Networking version 9.11.x.x and displays the Dell> prompt on the console. You can use the show version command to verify the
version of the installed software.
After you install Dell Networking OS version 9.11.x.x, you can connect the device to a C9010 as a port extender.
8
Convert a Dell N20xx or N30xx series Switch to a Port Extender
StartOnBoot AutoRestart CPU Sharing Max Memory
Yes
Yes
Yes
No
No
No
0
0
0
0
0
0

Advertisement

loading

This manual is also suitable for:

N30 series