Settings; Recorder Adjustment Setting; Setting - Canon ELURA10 A Service Manual

2. Settings

Perform the AF/EIS/ CAMERA adjustments in a complete-product state.

2-1 Recorder Adjustment Setting

<Purpose>
Check of each section, tape path adjustment, and recorder electrical adjustment are made with the front, rear, left and right cover
units removed.

2-1-1 Setting

<Procedures>
1) Solder the jumper wires (×2), TP2001 (PB-RF) and TP2002 (SWP) on the MAIN P.C.B.
2) Connect the cable of the Right Cover unit with the CN102 (R-KEY) and CN3201 (power supply).
3) To turn on the power, connect the cable of the Left Cover unit with the CN200 (P-DIAL).
*Connecting the TP203 and TP204 (MAIN P.C.B.) to ground can trun on the power also.
4) Operation by a LANC Remote Controller is possible by connecting the Docking Unit (DU-300) with the Multi Connector.
5) The power is suppliable via the DC-400 or connecting the Constant Voltage Supplier with the TP3201/3202 (DC+) and the TP3203/
3204 (DC-).
MONITOR TV
A/V JACK
Docking Unit
(DU-300)
V
L
R
IC1302
CN1401
TP202
(CAM PW SW)
TP204
(VTR PW
SW2)
Right
Cover Unit
Battery
Treminal
LANC REMOTE
COMMANDER
RM-95
Fig. 3-1
3-2
CAHPTER 3. INFORMATION FOR REPAIR · SERVICE HINTS
IC2000
MAIN P.C.B.
TP203 TP2002 TP2001
(VTR PW SW1) (SWP) (PB-RF)
Left Cover Unit
CN200
CN3201
Right Cover Unit
ELURA20 MC A, ELURA10 A
IC3201
FU3202
FU3201
TP3201
(DC −)
TP3202
(DC −)
TP3203 TP3204
(DC +) (DC +)
CN102
A/V JACK
DC-400