Closed Caption Detection/Output; Audio Dubbing; Tape Usable For Audio Dubbing; Selecting An Audio Dubbing Signal Input Source - Canon ELURA10 A Service Manual

7-11 Closed Caption Detection/Output

(1) Closed caption signal output
• When tape on which closed caption data are recorded is played back, the closed caption data is output superimposed over the
video signal.
• The caption data can be displayed on the screen if the monitor has a built-in closed caption decoder.
(2) Closed caption signal detection
• During analog or digital line input recording, the closed caption data in the input signal is detected and the closed caption data
is then recorded.

7-12 Audio Dubbing

7-12-1 Tape Usable for Audio Dubbing

Only tapes with 12-bit SP recording other than for dubbing 4-channel simultaneous recordings can be used. If an attempt is made
to use any other tape, the Stop mode will be activated.
If the LP mode, 16-bit mode, 4-ch simultaneous recordings, unrecorded or SDL (
(warning display).

7-12-2 Selecting an Audio Dubbing Signal Input Source

The audio dubbing input source is selected from the VCR menu.
Either of two items can be selected: Line (AV mini jack) or Mic. When Mic is selected, input will be from the external microphone
if one is connected; otherwise, input will be from the built-in microhone.

7-12-3 Audio Dubbing Operation

(1) In the VCR mode, position and pause the tape to be dubbed, then press the dubbing key of the remote control.
The dubbing mode will be activated (dubbing pause) and
(2) Press the Pause key and input sound into the microphone.
Dubbing will start.
(3) Press the stop I key to stop.
The dubbing mode will be canceled, the dubbing display will disappear and operation will stop.
• If the pause I key is pressed instead of the stop key, the dubbing mode will not be canceled and status (1) (dubbing pause) will
return.
• Dubbing can also be canceled by pressing the dubbing key during dubbing pause.
• Also, if the Zero Set Memory key of the remote control is pressed at the tape position where dubbing is to be ended, operation
will automatically stop and dubbing will be canceled when that position is reached after operation (2).
CHAPTER 1. GENERAL DESCRIPTION OF PRODUCT
LP mode) recordings are detected → Stop
SP /
E E
(dubbing pause) will appear on the LCD panel (CVF).
1-49
ELURA20 MC A, ELURA10 A