Separation Of Lens Unit, Sub P.c.b. And Recorder Holder - Canon ELURA10 A Service Manual

1-9 Separation of Lens Unit, SUB P.C.B. and Recorder Holder

(1) Detach two screws (m × 2) then remove the Lens Unit and Lens Sheet.
(2) Detach two screws (h × 2) and CN300, CN301, CN302, CN303, and remove the SUB P.C.B.
(3) Detach three screws (p × 2, q × 1) and the Spring, then remove the Recorder Holder.
Note : Be sure to face downward the cassette compartment side of the DMCII mechanism unit, from which the
recorder holder has been detached. (Facing the gear at the rear of main chassis downward may result in
damage to it.)
< Note on Reassembling >
(1) When attaching the Recorder Holder, note that there should be Rubber pieces at five locations.
(2) Before using the Insulation Rubber of service parts, coat the entire surface with Hanal KS-50M (DY9-3047-000).
UL Tape
h m
2.5mm
4.5mm
Metal
Metal
Metal
M1.7
M1.4
Note on Reassembling (1)
Set the side of cassette
compartment downward.
(1)
Lens Sheet
(2) - h
(2) - h
p q
3.5mm 3mm
Metal
M1.4
M1.4
Fig. 4-8
CHAPTER 4. DISASSEMBLING ADJUSTMENT
Lens Unit
(3)
UL Tape
UL Tape
Rubber
(2)
SUB P.C.B.
Spring
(2)
CN302
SUB P.C.B.
CN303
CN301
CN300
4-9
ELURA20 MC A, ELURA10 A
Recorder Holder
Rubber
(1) - m
(3) - p
Rubber
(1) - m
Rubber
(3) - q
(3) - p
(2)