After locating AC Ez installation Bracket at the
desired location, screw the unit firmly.
- Set it up not to bend because poor setup
could take place if setup board bends.
- Set remote controller board to the reclama-
tion box if there is a reclamation box.
• Use the screws provided.
Set up AC Ez cable in suitable connection
- In case of reclamation to the surface of the
wall : Use the cable hole of bracket.
- In case of no reclamation to the surface of
the wall : Use the right part guide groove.
Fix it by using screw provided at the lower
part tightly after wet it up the bracket.
• It can crash on the floor by the impact, if
screw is not fixed.