Installation setup mode #1 _ Master/Slave setting
1
If pressing
- If pressing once shortly, it doesn't enter into installer setup mode.
Please press more than 5 seconds for sure.
2
When entering the Master/Slave setting mode, it displays '01' and blinks
in LCD. It shows on #1 of setup mode by blinking the on/off led of indoor #1.
3
Select Master/Slave setting condition by pressing
4
Apply desired time setting by pressing the
After pressing
LCD stops blinking.
NOTE
!
• After setting, if you press the
onds, it exits from installation mode automatically.
• If you exit installation mode without pressing
• If you press individual on/off button of corresponding installation mode to change, you can
enter corresponding installation mode directly.
button long for 5 seconds, it enters into AC Ez setup mode.
button, corresponding setting condition is saved,
button or it doesn't have any button input for 20 sec-
INSTALLATION INSTRUCTION
button.
button.
button, changed value don't apply.
15
M
S
or
M
S
or
of