Xinje XC Series User Manual page 104

ID Function
M8020 Zero
M8021 Borrow
M8022 Carry
M8023
M8026 RAMP Mode
M8029
ID Function
M8030 PLC initializing
M8031 Non-retentive register reset
M8032 Retentive register reset
M8033 Registers keep stopping
M8034 All output forbidden
M8038 Parameter setting
ID Function
M8041
M8045 All output reset forbidden
M8046 STL status activate
Flag (M8020-M8029)
The plus/minus operation result is 0
"borrow" occurs in minus operation
When carry occurs in plus operation or overflow
occurs in bit shift operation
PC Mode (M8030-M8038)
When driving this M, ON/OFF mapping memory of
Y, M, S, TC and the current values of T, C, D are all
reset to be 0
When PLC changes from RUN to STOP, leave all
content in mapping registers and data registers
Set PC's all external contacts to be OFF status
Set communication parameters flag
Stepping Ladder (M8041-M8046)
When shifting the mode, all outputs reset
functions are forbidden
When M8047 activating, act when any device of
S0~S999 turns to be ON
Appendix special soft device list
Description
Description
Description