Installing A 5¼-Inch Device (Short Tower Computers) - DEC Digital PC 3500 System Reference Manual

Adding Mass Storage Devices
Installing a 5¼-Inch Device (Short Tower Computers)
The following procedures describe how to install 5¼-inch device into a front-access
device bay.
NOTE
determine if switches or jumper settings need to be set or installed
on the device. Set all switch and jumper settings accordingly.
1. Turn off your computer and monitor.
2. Disconnect all external devices, ac power, and monitor power.
3. Remove the outside cover.
4. Remove the front bezel (see Figure 6-8).
5. If necessary, remove the filler panel from the front bezel.
6. Remove the EMI shield filler plate (if applicable).
7. Remove the drive rail from the inside of the chassis.
8. Using the supplied drive rail and mounting screws, install the 5¼-inch device
into the appropriate device bay.
9. If necessary, replace the filler panel.
10. Connect the power and data cables to the 5¼-inch device.
Refer to "Connecting Diskette and IDE Devices (Short Tower Computers)" later in this
chapter.
6-20
: Refer to the manufacturer's instructions for your device to