Adding Mass Storage Devices
Installing a 3½-Inch Device (Low Profile Computers)
The following procedures describe how to install a 3½-inch device into the bottom-
right device bay.
NOTE
determine if switches or jumper settings need to be set or installed
on the device. Set all switch and jumper settings accordingly.
1. Turn off your computer and monitor.
2. Disconnect all external devices, ac power, and monitor power.
3. Remove the outside cover and if necessary, remove the filler panel.
4. Remove the EMI shield filler plate and the drive rail from the inside of the
chassis.
5. Install the brackets and the drive rail onto the 3½-inch device.
Figure 6-2. Installing Drive Rail and 3½-Inch Device Brackets (Low Profile
6-6
: Refer to the manufacturer's instructions for your device to
Computers)
DEC00723