Removing The Front Bezel (Short Tower Computers) - DEC Digital PC 3500 System Reference Manual

Adding Mass Storage Devices

Removing the Front Bezel (Short Tower Computers)

To install mass storage devices into the front access drive bays you must first
remove the front bezel. To remove the bezel:
1. Turn off your computer and monitor.
2. Disconnect all external devices, ac power, and monitor power.
3. Remove the outside cover.
4. From the top of the computer, looking down towards the bottom of the front
of the chassis, you should see two tabs from the front bezel that hold the
bezel in place and secure it to the chassis. Find both tabs (one on the left
and one on the right).
5. By pushing on both of these tabs towards the center of the computer, you
can release the top of the bezel.
6. Gently pull the top of the bezel approximately an inch away from the top of
the chassis.
7. Gently but firmly, pull up on the bezel to detach the bottom bezel mounts.
6-16