Setting Up The I-Pad Cu-Sp1 Auto - CU Medical Systems i-PAD CU-SP1 AUTO Instructions For Use Manual

WARNING
Only parts and accessories recommended and approved by CU Medical Systems, Inc. must be
used with the i-PAD CU-SP1 AUTO. Using unapproved parts and accessories may compromise
the safety and effectiveness of the i-PAD CU-SP1 AUTO.
Extra battery packs and pads are recommended.

3.2 Setting up the i-PAD CU-SP1 AUTO

Do the following to set up the i-PAD CU-SP1 AUTO
① Open the package and verify that it contains all the items listed in the packing list.
② Familiarize yourself with the device features by referring to [Chapter 2: Device Features] of
these Instructions for Use.
③ Insert the battery pack into the battery compartment on the device as shown in the figure
below.
As the battery pack is inserted, the device starts a self-test. If the device status is normal,
is shown on the Status LCD. If
test, please refer to [Chapter 8: Troubleshooting] of these Instructions for Use.
④ If you have a carrying case, please safely store the Device in the carrying case. If you want
to purchase the carrying case, please contact us by referring to [Appendix A: Accessories] of
these Instructions for Use.
⑤ Storage and maintenance considerations:
, or is displayed on the Status LCD after the self-
14