Assistance And Replacements - Electrolux 12550 G-M User And Installation Instructions Manual

On base cabinet with oven
The compartment must have the dimensions given in the figure on the previous page and
must have supports to allow efficient ventilation.
To avoid excessive overheating, it is advisable to carry out installation as shown in the figures
below.
The electrical connection of the hob and oven must be carried out separately, for electrical
reasons and to facilitate frontal oven removal.
Wall units or extractor hoods must be at least 650 mm from the hob.
In case of 600 mm wide hoods, as well as respecting the height, wall units next to the hood
must be positioned at a height of at least 550 mm from the top, to enable possible fitting of
the cover and its correct use.

ASSISTANCE AND REPLACEMENTS

Before leaving the factory this appliance was tested and adjusted by expert and specialised
personnel in order to ensure best operation. Any repairs or adjustments subsequently
required must be carried out with maximum care and attention.
Therefore always contact the Dealer who sold the product or our nearest After-Sales Service
Centre, specifying the type of problem, appliance model (Mod.), product number (Prod. No.)
and serial number (Ser. No.). These details are given on the label in the bag of injectors
supplied.
Original replacements, certified by the product manufacturer, and
identified by this mark, are only available at our After-Sales Service
Centres and Authorised Replacement Parts Shops.
2
50 cm
2
360 cm
Assistance and replacements 33
2
120 cm
2
180 cm