KitchenAid KSM75 Service Manual page 8

Stand Mixer Service Manual LIT4177310-C
Fig. 10 Removal of the 5 special screws holding the
internal gear in the bottom cover.
Fig. 11 The bottom cover is removed after removing the
four #10-24 filister head screws.
To remove the bottom cover from the gearcase-
motor housing, insert a drift punch through the hole
in the center shaft and lift, while using a screwdriver
to break the bottom cover loose.
Use the slots in the side of the gearcase to do
this (Fig. 12).
Do NOT pry in the area of the transmission gasket,
as this may prevent the gasket from sealing properly
upon reassembly.
The transmission gears will come out with the
bottom cover. Be careful not to allow any grease to
fall into the motor area of the housing.
KITCHENAID
Fig. 12 While lifting up on the center shaft, use a screw
H. Remove the attachment hub bevel gear from
the gearcase-motor housing.
This gear is removed by simply pulling it out of
the attachment hub (Fig. 13). The gear will clear
the worm of the motor's armature shaft and
should be easy to remove.
Note:
no grease shown in the gearcase. Normally the
gearcase has 6 oz. of grease surrounding the gears.
Fig. 13 The attachment hub bevel gear being removed
from the mixer attachment hub bearing.
I. Clean out the gearcase and remove as much of
the grease as possible.
The gearcase may be thoroughly cleaned when
the motor has been removed.
Page 5
driver to gently pry the bottom cover from the
housing.
For clarity, the pictures in this manual have
2005 KitchenAid