KitchenAid KSM75 Service Manual page 17

Stand Mixer Service Manual LIT4177310-C
Fig. 43 Slide the speed control link over the flat spring and
attach the speed control spring to the link.
Place the stud on the speed lever through the hole
in the speed control link.
Place the tension washer on the pivot screw and
screw it into the gearcase-motor housing until tight
(Fig. 44).
Fig. 44 Securing the pivot screw to the gearcase after
placing the tension washer.
M. If the spring in the governor is rusty, replace
the governor assembly.
Place the governor drive pin in the armature shaft.
With drive pin at top of the shaft, place the
governor on the shaft with the keyway up (Fig.45).
Push the governor onto the shaft as far as it will
go.
NOTE: Never attempt to take the governor apart.
The purpose of this picture is to show where
governor seats on drive pin (Fig. 46).
KITCHENAID
Flat Spring
Speed Control Spring
Fig. 45 The governor shown before being placed on the
Fig. 47 Using a 3/8" nut driver to seat the governor. Tap
Page 14
motor shaft.
gently. Never drive directly against governor ball.
2005 KitchenAid