KitchenAid KSM75 Service Manual page 15

Stand Mixer Service Manual LIT4177310-C
The two long leads from the stator must be on the
same side as the slot in the motor housing. Insert the
stator brush clips between the brush holder housing
and brush insert.
A slot is provided in the brush holder housing for
this brush clip. Insure that the brush clips are pushed
in all the way so the brush and commutator on the
armature will clear them when assembled.
E. Push the stator back as far as it will go, then
place the star washers and #10-24 nuts on each
stator stud.
Tighten both nuts.
Put the long leads from the stator through the slot
in the bottom of the motor housing (Fig. 37).
Stator Wires
Routing Of
White Wire
Fig. 37 Route the two stator wires through the slot in the
motor housing.
Place the stator stud sleeve over the stator stud and
route the white wire from the stator between the stud
sleeve and the motor housing.
F. Check the armature on a growler or take the
armature to a electric motor repair shop and let them
test it.
If it is not in good condition, replace it with a new
one.
G. Check the ventilating fan. Straighten the blades
if they are bent (Fig. 38).
If the armature is replaced, move the washers from
the old armature to the corresponding end of the new
armature.
Add one drop of Locktite to the outer race of the
ball bearing and install the armature in the
motor housing (Fig. 39).
KITCHENAID
Bearing Washer
Fig. 38 Check the blades of the armature ventilating fan
Fig. 39 Locating the armature into the gearcase-motor
with a non-metallic mallet to seat the armature
bearing into the gearcase-motor housing.
H. Check the bearing in the bearing bracket.
clip (Fig. 40).
tongue fits into the square notch and push the
retainer clip in place.
Page 12
and straighten if bent.
housing.
If necessary, tap the end of the armature shaft
To replace the bearing, remove the retaining
Take out the felt washer and the old bearing.
Place the new bearing in cavity.
Soak the felt washer with oil and place in cavity.
Place the retainer on the bearing so that the
2005 KitchenAid
Spacing Washer