KitchenAid KSM75 Service Manual page 10

Stand Mixer Service Manual LIT4177310-C
Fig. 18 Mixer housing with end seal and
control board removed.
B. The phase control can now be disassembled from
the bearing bracket, if necessary, by unscrewing the
#4-40 x 1/4" pan head screw (Figs. 19 & 20).
Fig. 19 Removal of the phase control (Triac)
from the bearing bracket.
C. With a pair of needle nose pliers, carefully pry
off the governor assembly. (Fig. 21) Do NOT
bend.
Remove the governor drive pin and lay it aside so
it will not be lost (Fig. 22).
KITCHENAID
Page 7
Fig. 20 Phase control or (triac) shown
removed in lower center.
Fig. 21 Needle nose plier used to pry governor off
the motor shaft.
Fig. 22 Governor shown removed from the shaft
of the motor.
2005 KitchenAid