KitchenAid KSM75 Service Manual page 22

Stand Mixer Service Manual LIT4177310-C
P. If necessary to replace the internal gear, pry it
from the bottom cover (Fig. 61).
Fig. 61 Internal gear can be pried from the bottom cover and
replaced if necessary.
When installing new gear, start with beveled side
down; align notches with holes in gear case and tap
evenly into place using a non-metallic mallet.
Insert and tighten the five special screws evenly
(Fig. 62) to 18 - 20 in. lbs. torque.
2
3
Fig. 62 Tighten the five special screws evenly to 18-20 in.
lbs.. torque using the sequence shown.
Insert the four #10-24x1" fillister head screws into
the bottom cover making sure they are tight (Fig. 63)
(18 - 20in/lbs.).
Q. Place a small amount of Benalene 930-2
lubricant on the teeth of the internal gear.
R. Check the condition of the planetary. If there is
any play in the agitator shaft and the bearing (not
shown), replace the planetary and the shaft.
KITCHENAID
4
1
5
Page 19
Fig. 63 Secure the four fillister head screws.
The bearing is an integral part of the planetary.
Hold the agitator shaft firmly and remove the
pinion retaining clip (Fig. 64).
Fig. 64 Hold the agitator shaft and remove the retaining
clip.
Lift off the pinion. Take out the pin and remove
the washer (Fig. 65). Pull the agitator shaft out.
Fig. 65 Lift the pinion off and take out the pin and
remove the washer; then pull out the shaft.
2005 KitchenAid