KitchenAid KSM75 Service Manual page 31

Stand Mixer Service Manual LIT4177310-C
If not, adjust the bowl height by turning the beater
height adjusting screw clockwise to decrease the
clearance or counter clockwise to increase the bowl to
beater clearance (Fig. 97).
Fig. 97 Adjusting the beater to bowl height using the
adjusting screw.
Q. Both "Bowl Lift' and "Tilt Head"international
export models require an "R F" filter that is mounted
to the bottom cover of the motor housing with a
single round head screw (Fig. 75).
KITCHENAID
NOTE: Newer models have an adjusting screw
A. If the beater rubs the bottom of the bowl, it can
be corrected by turning the adjusting screw out.
If the unit has no adjusting screw, it can be
corrected by tapping the yoke arms down evenly
with a mallet.
There should be 1/16" clearance between the
bowl and beater.
B. If too much clearance between beater and bowl,
adjust the screw in until the 1/16" beater to bowl
clearance is met.
If unit has no adjusting screw, use a mallet to tap
both sides of the yoke up evenly until the 1/16"
beater to bowl clearance is met.
If beater to bowl clearance is not met, you will
have to change the bowl support.
NOTE: The 1/16" clearance can be determined
by dropping a dime in the bowl. The flat beater
should just "touch" the coin as the beater rotates.
C. If the bowl rocks on the bowl support, this is
caused by a broken bowl spring latch.
Remove the two screws and place a new latch in
position.
Screw in the two screws tightly. (Fig. 95)
D. If the bowl retaining pins are worn, the bowl
will move on the pins and the beater will hit the
sides of the bowl.
To replace the pins, twist and pull up at the same
time. They are not difficult to remove.
To install the new pins in the bowl support, place
pins in holes, support the end of the arms with a
heavy object, and drive the pins down gently.
Be careful not to bend the arms of the bowl
support.
Page 28
SECTION 8
TROUBLESHOOTING THE BOWL LIFT
STYLE ASSEMBLY
located on the top center of the column for
adjusting the bowl to beater clearance.
2005 KitchenAid