KitchenAid KSM75 Service Manual page 9

Stand Mixer Service Manual LIT4177310-C
SECTION 2
DISASSEMBLY OF STAND MIXER MOTOR
AND CONTROL UNIT
Note: All service operations discussed
here should be performed with the mixer
disconnected from the A. C. mains.
A. Start the disassembly of the control unit by
removing the cord flag terminals from the control
board and the ground wire from the bearing bracket
(Fig. 14).
Fig. 14 Removal of the cord flag terminals and
cord ground wire.
Remove the motor stator flag terminals from the
control board ( Fig. 15).
Fig. 15 The removal of the motor stator flag
terminals from the control board.
KITCHENAID
Remove the end seal and disconnect the phase
control flag terminals from the control board
(Fig. 16).
Unhook the control board spring at the bottom of
the control board (Fig. 17).
Unlock the two lock nuts on the control board a
unscrew the two adjusting screws.
The mixer control board can now be removed a
set aside for later evaluation (Fig. 18 ).
Page 6
Fig. 16 After removing the end seal, remove the
phase control flag terminals.
Fig. 17 Unhook the control board spring.
2005 KitchenAid
nd
nd