Repeat Operation - Samwontech TEMP2020 series Operation Manual

SAMWONTECH

5.2 REPEAT operation

▶ Press [REPEAT SET] button on PROGRAM SET menu screen to enter into this screen.
▶ This screen is to set repeat operation of entire current pattern and partial segment operation after
complete of current operation.
▶ Following screen explains for CH1, and it is same for CH2 screen.
①
②
③
④
⑤
⑥
① Setup box to input pattern number for repeat operation.
② Setup box to input count number for current entire pattern repeat.
③ Setup box to input next pattern number to run continually after complete of current operation.
④ Setup box to input start segment number for partial repeat operation.
☞ When the starting Segment is '1', it starts with Start Set Point (SSP) regardless of Start Code(STC).
⑤ Setup box to input end segment number for partial repeat operation.
⑥ Set Setup box to input count number for partial repeat operation.
⑦ Displays of experiment name for current pattern.
☞ The experiment name can be set at [5.6 PATTERN NAME].
☞ This Displays is just READ ONLY and cannot be changed on this screen.
⑧ Move to CH1 or CH2 screen.
⑨ Button to set PATTERN END MODE for operation state after complete of operation.
☞ RESET: Make program operation STOP with generating PTEND signal.
☞ SEG HOLD: Stay operation run with holding SP at last segment.
☞ LINK RUN: Resume pattern operation number set as LINK PATTERN.
Table5-2. REPEAT SET PARAMETER
Parameter
CH1 PATTERN NUMBER
CH2 PATTERN NUMBER
REPEAT COUNT
CH1 LINK PATTERN
CH2 LINK PATTERN
PATTERN END MODE
START SEG. for Partial repeat
END SEG. for Partial repeat
REPEAT COUNT for Partial repeat
1st Edition of TEMP2020_Series IM : Dec. 15. 2008
[Figure 5-3] REPEAT SET screen
Range
1~40
1~40
0(infinite)~999
1~40
1~40
RESET, SEG HOLD, LINK RUN
0~99
0~99
0~99
⑦
⑧
⑨
Unit Default
ABS 1
ABS 1
ABS 1
ABS 1
ABS 1
ABS RESET
ABS 0
ABS 0
ABS 0
Page 46 / 71