Turning Stimulation On; Adjusting Stimulation Intensity - Bioness StimRouter User Manual

Turning Stimulation On

Adjusting Stimulation Intensity

The remote control stores up to nine stimulation intensity settings. These
settings are numbered "1–9"; "0" equals no stimulation. When the
remote control is first turned on, the stimulation intensity level should be
"5," which is the customary default level set by the clinician. Normally,
To select a stimulation program:
From standby mode, press and hold the mode button for at least
1
three seconds, until the remote control beeps and the mode button
glows yellow. A letter will appear in the digital display, indicating
the active program.
Press the plus or minus button to change the active program. The
2
new active program will appear in the digital display.
Press the mode button briefly to return to standby mode. The remote
3
control will beep, the mode button will turn off, and the default
stimulation intensity level will appear in the digital display.
To turn stimulation on:
Stimulation Off
From standby mode briefly press the mode button. The remote
1
control will beep and the mode button will start flashing yellow.
Few a few seconds, the digital display will alternately show the
2
active program and active stimulation intensity level.
After a few seconds, the digital display will show only the
3
stimulation intensity level.
After a few minutes, the digital display will go dark.
4
Stimulation On
Operating Instructions 8-33