Unpacking And Chacking The Components; 1Unpacking - Canon Finisher-R1 Installation Procedure

Chapter 1

1.2 Unpacking and Chacking the Components

1.2.1 Unpacking
Memo: The machine is packed using tape and cushioning material to protect against vibration and shock during
transit. Be sure to remove them before starting to install the machine. (It is a good idea to store away the
removed tape and cushioning material for possible relocation of the machine, e.g., to a new site or for repairs.)
1) Take out the accessory box and the attachments from the shipping box.
At this point, do not remove the 4 cushioning materials (Styrofoam) from the finisher. Otherwise, you would
likely deform some areas of the machine.
2) Lift the finisher together with its cushioning base (Styrofoam). Be sure to work in a group of 2 persons.
If you shift up the finisher on its side, you would likely deform or damage the machine. Moreover, in the case of
the Saddle Finisher-R2, force applied to the front cover [1] can deform the hinge.
6
F-1-5
0003-1759