Canon Finisher-R1 Installation Procedure page 27

<Saddle Finisher-R2>
1) Open the front cover; then, from the back of the front cover, remove the fixing screw, and detach the pliers [1].
■ Adjusting the Height
1) Loosen the 2 fixing screws [1] each of the casters at the front and rear of the finisher pickup side.
2) If you want to increase the height of the finisher, turn the adjusting bolt [2] in the direction of arrow A of the figure.
(A full turn of the adjusting bolt will increase the height of the finisher by 1.75 mm.) Refer to the index in the caster
area when adjusting the height. Perform this for both front and rear casters.
3) If you want to decrease the height of the finisher, turn the adjusting bolt [2] in the direction of arrow B. (A full
turn of the adjusting bolt will decrease the height of the finisher by 1.75 mm.) Refer to the index in the caster area
when adjusting the height. Perform this for both front and rear casters.
[1]
F-1-32
[1]
F-1-33
Chapter 1
19