Canon Finisher-R1 Installation Procedure page 28

Chapter 1
■ Adjust the Tilt
1) Loosen the 2 fixing screws [1] 2 each on the front and rear casters of the finisher delivery side.
2) If you want to decrease the gap between the finisher and its hot machine, turn the adjusting bolt [2] in the direction
of A. (A full turn will increase the height of the finisher by 1.75 mm.)
3) If you want to increase the gap between the finisher and its host machine, turn the adjusting bolt [2] in the direction
of arrow B. (A full turn of the adjusting bolt will decrease the height of the finisher by 1.75 mm.) Adjust the tilt by
referring to the index in the caster area. Perform this for both front and rear casters.
■ Making Checks After Making Adjustments
1) Check to see that the difference in height between the finisher and the host machine and the tilt are as indicated
once again. Otherwise, start over the foregoing steps.
2) When done, tighten the 2 fixing screws [1] each on the casters.
3) To prevent loosening of the adjusting bolts after installation (as by relocation), turn each adjusting bolt [2] about
90 deg in the direction of the arrow. Do not turn them more than 90 deg; excess tightening can displace positions.
20
[2]
[1]
A
F-1-34
[2]
[1]
A
F-1-35
B
B