Removing The Shift Tray Driver Pcb - Canon Shift Tray-D1 Service Manual

Chapter 3
F-3-23
3.3.1.2 Removing the Shift
Tray Driver PCB
1) Free the 2 retaining claws [1], and detach the cable
retaining plate [2].
[2]
[1]
F-3-24
2) Remove the 2 screws [3], and detach the 2 tray full
sensors [4] and the 2 grounding wires.
3) Free the cable of the tray full sensor from the clamp
[5], and disconnect the connector [6].
[4]
[6]
F-3-25
3-6
[1]
0009-3528
[3]
[4]
[5]
4) From the back of the shift tray, remove the 4 screws
[7] and detach the 4 shaft retainers [8]; then, detach
the tray drive assembly [9].
[8]
[9]
F-3-26
5) Pull off the shaft [10] from the tray drive assembly;
then, remove the 3 screws [11], and detach the shield
cover [12].
[12]
F-3-27
6) Disconnect all connector from the shift tray driver
PCB.
7) Remove the 5 screws [13], and detach the shift tray
driver PCB [14].
[7]
[8]
[11]
[10]