Removing The Front Door; Removing The Rear Upper Cover; Tray 1 - Canon Finisher-T1 Service Manual

4) Remove four screws [3] and remove the finisher
controller PCB [4].
[1]
[3]
F-3-84
5) Release the claw [1] of the stack delivery roller rear
side clutch [2] and remove the clutch [2].
6) Remove the E ring [3], washer [4], and bearing [5]
and remove the stack delivery roller.
[3] [4] [5]
F-3-85
7) Disconnect two connectors [1] and remove harness
from the clamp and edge saddle [2].
8) Remove two screws [3] and pull out the processing
tray [4] in the paper delivery direction.
When removing parts inside the processing tray,
be careful not to exert force on the aligning plate
(front/rear) or the rear end stopper plate.
[2]
[4]
[2]
[3]
[1]
[2]
F-3-86

3.3.2 Tray 1

3.3.2.1 Removing the Front
Door
1) Open the front door [1] and remove the clip [2].
2) Lift the front door [1] to remove.
[1]
F-3-87
3.3.2.2 Removing the Rear
Upper Cover
1) Remove four screws [1] and remove the rear upper
cover [2].
Chapter 3
0009-4507
[2]
0009-4510
3-23