Removing The Grate-Shaped Lower Guide; Removing The Processing Tray - Canon Finisher-T1 Service Manual

Chapter 3
F-3-131
3) Lift tray 2 [1] to remove it.
[1]
F-3-132
When installing the tray, be careful not to twist the
tray cable. To prevent the gear phase from shifting
due to the front and rear rails, the tray must be
attached horizontally. Lower the tray [1] to the
position shown in the figure and compare the
heights of the shutter guide top edges [2] with those
of the tray projections [3] at the front and rear to
check that the tray is attached horizontally. If their
heights are not the same, remove the tray and then
attach it again.
3-34
[2]
[1]
[2]
[1]
F-3-133
3.3.5.8 Removing the Grate-
shaped Lower Guide
1) Remove ten screws [1] and remove the grate-
shaped lower guide [2].
When replacing, be careful not to hook the grate-
shaped lower guide to the sensor flag arm on the
delivery side.
[1]
[2]
F-3-134
3.3.5.9 Removing
Processing Tray
1) Unfasten four snap fasteners [1] and remove the
sensor flag [3] from the stack delivery roller [2].
[3]
0009-4520
[1]
[1]
the
0009-3719