Maintenance And Care - AL-KO Snow Line 560 II Operating Manual

GB
Changing the wheel drive speed
1. Release (disengage) the auger and wheel drive
clutch levers ( 38-1).
Change the drive speed only when disengaged
2. Change the drive speed using the speed selector
( 38-2).
Unclogging the snow discharge chute
If snow does not discharge properly, the augers or
1. Release (disengage) the auger and wheel drive
clutch levers ( 38-1).
2. Switch off the engine.
3. Disconnect the spark plug connector.
4.
chute and auger using the snow cleaning tool
( 39-1).
If snow still does not discharge properly, contact a quali-

Maintenance and care

Danger - risk of injury!
always switch off the engine and disconnect the
spark plug connector.
Do not hose down the unit with water!
Replace the silencer if defective.
Maintenance schedule
Before each use
30
Check the shear pins.
Every three months
Check the tyre pressure.
Lubricate the snow discharge chute ring with
spray oil ( 11).
Annually
Lubricate auger.
Lubricating the auger
Using a grease gun, inject 2 to 3 shots of universal
grease into the grease nipple (
Maintaining the wheel drive
Adjusting the control cable
If the wheel drive no longer engages when the engine is
Caution!
Switch off the engine before adjusting the con-
trol cable.
1. Loosen the lock nut (
2.
direction of the arrow (
the clutch lever is pressed. Hold the cable while
tightening so that it does not twist.
3. Tighten the lock nut.
4.
engaging the wheel drive.
5. If the wheel drive still does not engage and
Translation of original user instructions
AL-KO snow blower
40).
41-1).
41-2) until the control
-