Cleaning With The Floss Attachment - Nevadent NSZB 3.7 B3 Operating Instructions Manual

Cleaning with the floss attachment

You can use the floss attachment e to clean interdental spaces with the aid of
dental floss .
1) Place the floss attachment e on the hand element .
2) Take around 15 cm of standard commercial dental floss and wrap one
end around the fixture w 2–3 times .
NOTE
If the dental floss slips off the fixture w, you can tighten the screw with a
Phillips screwdriver .
3) Pass the dental floss tightly through the guide grooves q on the floss at-
tachment e .
4) Then wrap the other end around the fixture w 2–3 times so that the
dental floss is stretched taut and does not come undone while cleaning the
interdental spaces .
5) Guide the dental floss between two teeth with the toothbrush switched off .
6) Switch the appliance on . When cleaning with the floss attachment e, use
the settings "Clean" or "Soft" .
7) Clean the interdental space with careful up-and-down movements .
8) Clean all the interdental spaces as described above .
9) When you are finished, switch off the toothbrush and take it out of your
mouth .
10) Remove the dental floss from the fixture w and dispose of it .
11) After use, clean the floss attachment e thoroughly under running water .
12) Remove the floss attachment e from the hand element .
To clean the drive shaft 2 and the handset, hold them under running water
for a short while . Hold the handset so that the drive shaft 2 is pointing
downwards at an angle .
NSZB 3.7 B3
GB │ IE │ NI │
7 ■