Working Principle - Larius VEGA 23:1 Operating And Maintenance Instruction Manual

WORKING PRINCIPLE

A A
VEGA 23:1 pump is a pneumatic pump for high pressure painting
without the use of compressed air (AIRLESS). The stainless steel
version is particularly suitable for use with water-based paints.
The pump is essentially composed of an air motor and a structure
known as "Product Pumping unit", or simply the "Pumping unit".
In the pneumatic motor, the compressed air causes the vertical
reciprocating movement of the motor piston; this movement is
transmitted through a connecting rod to the product pumping piston.
This allows the pump to suck the product and to feed it towards
the outlet.
The ratio 23:1 means that the outlet pressure of the product is 23
Fields of application
Wood
Carpentry
Handcraft
Small and medium industry
for limited productions
VEGA 23:1
times higher than the pump feed air pressure.
The unit comes complete with a transportation trolley, a high-
pressure product filter, an air supply regulator for the pump, a
product suction tube (complete with filter) and a recirculation tube.
Our spray guns are tested and controlled in our factory and are
derivered to the customer in perfect working conditions.
for this rason, in order not to alter the characteristics of these
units, it is advisable to carefully read these instructions and to
follow them accordingly.
Trolley version
Version on tank
Main application products
Paints for wood in general
Very well ground enamels and rust preventers
Primers
Polyurethan paints
Lakes
3
Wall bracket version
Degreasers
Detergents
Oils
etc...