Table of Contents
Advertisement
A
WORKING PRINCIPLE
The STORM 5 unit is defined "electric piston pump".
An electric piston pump is used for high pressure painting without
air (from this process derives the term "airless").
The pump is controlled by an electric motor coupled with a
reduction gear.
A cam shaft and a connecting rod allow to obtain the reciprocating
motion necessary to the working of the "pumping group" piston.
The piston movement produces a "vacuum".
The product is sucked, pushed towards the pump outlet and then
B
TECHNICAL DATA
SUPPLY (single-phase)*
SUPPLY WITH RUN GENERATOR
MOTOR POWER
MAX. WORKING PRESSURE
MAX. DELIVERY
MATERIAL OUTLET
WEIGHT
LEVEL OF THE SOUND PRESSURE
LENGTH
WIDTH
TOTAL HEIGHT ON TROLLEY
HEIGHT ON TROLLEY WITHOUT HANDLE
*Available on request with special voltages
PARTS OF THE PUMP IN CONTACT WITH THE MATERIAL Stainless Steel AISI 420B, Teflon; Aluminium
STORM 5
sent to the gun through the flexible hose.
A mechanical device on the side of the reduction gear casing,
allows to adjust and control the pressure of the material coming
out of the pump.
When the pump reaches the set value, the motor stops and starts
again when the value decreases.
A safety valve avoiding overpressure, guarantees the total reliability
of the equipment.
STORM 5
220V C.A. 50Hz
minimum 9Kw asynchronous
2 kW (2,7 CV)
200 bar (2900 psi)
4,5 L/min (1,29 L/min)
M16 x 1,5 (M)
38 Kg
≤ 70dB(A)
(A) 500 mm
(B) 500 mm
(C) 1030 mm
850 mm
2
Advertisement
Table of Contents
