Fcc Notice - DMP Electronics CellCom series Compliance Listing Manual

FCC NOTICE

This device complies with Part 15 of the FCC Rules. Affix the included FCC label to the exterior of the panel enclosure in
plain sight. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made by the user and not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment. The antenna(s) used for this transmitter must be installed to provide
a separation distance of at least 20 cm from all persons.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If necessary, the installer should consult the dealer or an experienced radio/television technician for additional
suggestions. The installer may find the following booklet, prepared by the Federal Communications Commission, helpful:
This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402
CellCom SERIES UNIVERSAL ALARM
COMMUNICATOR
Specifications
Primary Power
Nominal 12VDC or 24VDC
Current Draw at 12VDC:
Standby 64mA
Alarm 109 mA (Peak Cellular Communication)
Current Draw at 24VDC:
Standby 30mA
Alarm 82 mA (Peak Cellular Communication)
"How to identify and Resolve Radio‑TV Interference Problems."
Stock No. 004‑000‑00345‑4
Information furnished by DMP is believed to be accurate and reliable.
This information is subject to change without notice.
Designed, engineered,
and manufactured in
Springfield, Missouri using U.S.
and global components.
LT-1620 1.02 18512
Certifications
Cellular
• LTE FCC Part 15 ID: RI7ME910C1NV
CellComSLC, CellComSLCZ, CellCom-LTE-V,
CellComZ-LTE-V
FCC Part 15 ID: CCKPC0163
IC: 5251A‑PC0163
Underwriters Laboratory (UL) Listed
• ANSI/UL 1610 Central Station Burglar (Cellular)
• ANSI/UL 1023 Household Burglar
• ANSI/UL 985 Household Fire Warning (CID Capture)
CellComSLCF, CellComF-LTE-V
Underwriters Laboratory (UL) Listed
• ANSI/UL 864 Fire Protective Signaling Systems
(CID Capture)
I N T R U S I O N • F I R E • A C C E S S • N E T W O R K S
2500 North Partnership Boulevard
Springfield, Missouri 65803-8877
800.641.4282 | DMP.com