Shuttle FN25 User Manual page 66

Onboard FDC Controller
This item specifices onboard floopy disk drive controller. This setting
allows you to connect your floopy disk drives to the onboard floopy
connector.
Ø The Choice: Enable or Disabled.
Onboard Serial Port1
This option is used to assign the I/O address and interrupt request(IRQ) for
the onboard serial port1(COM1).
Ø The Choice: Disabled, 3F8-IRQ4, 2F8-IRQ3, 3E8-IRQ4, 2E8-IRQ3,
or Auto.
Onboard Infrared Port
This option is used to assign the I/O address and interrupt request(IRQ) for
the onboard infrared port.
Ø The Choice: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3,
or Auto.
UART Mode Select
This item allows you to select IrDA infrared through COM2 port.
Ø The Choice: IrDA, ASKIR or SCR.
UR2 Duplex Mode
This item allows you to select the IR half or full duplex function.
Ø The Choice: Full or Half.
Onboard Parallel Port
This item allows you to determine onboard parallel port controller I/O
address and interrupt request(IRQ).
Ø The Choice: Disabled, 378/IRQ7, 278/IRQ5 or 3BC/IRQ7.
Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select
Normal, Compatible, or SPP unless you are certain your hardware and
software both support one of the other available mode.
Ø The Choice: SPP, EPP, ECP or ECP+EPP.
ECP Mode Use DMA
When the onboard parallel is set to ECP mode, the parallel port can use
DMA3 or DMA1.
Ø The Choice: 1 or 3.
- 61 -