Shuttle FN25 User Manual page 68

Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off
Blank Screen
DPMS Supported
Ø The choice: V/H SYNC+Blank, Blank Screen or DPMS Supported.
HDD Power Down
The IDE hard drive will spin down if it is not accessed within a specified
length of time. Options are from 1 Min to 15 Min and Disable.
Ø The choice: Disabled or 1 Min ~ 15 Min.
HDD Down In Suspend
The item allows you to enabled or disabled the HDD Down In Suspend.
Ø The choice: Enabled or Disabled.
Soft-Off By PBTN
Pressing the power button for more than 4 seconds forces the system to
enter the Soft-Off state when the system has " hung".
Ø The choice: Delay 4 Sec or Instant-Off.
PWRON After PWR-Fail
This item allows you to select power on function when power fail.
Ø The choice: Former-Sts, Off or On.
WOL(PME#) From Soft-Off
If this item sets to Enable, the system power will be turned on when the
LAN port receives an incoming signal. You have to connect the fax/mo-
dem to the mainboard Wake On LAN connector for this feature to work.
Ø The choice: Enabled or Disabled.
WOR(RI#) From Soft-Off
If this item is enable, it allows the system to resume from a software power
down or power-saving mode whenever there is an incoming call to an
installed fax/modem. You have to connector the fax/modem to the
mainboard.
Ø The choice: Enabled or Disabled.
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
This option only writes blanks to the video
buffer.
Initial display power management signaling.
- 63 -