Internal Peripherals Connectors Enhanced Ide, Floppy Connectors; Serial Ata Connectors - Shuttle FN25 User Manual

F
Internal Peripherals Connectors
Enhanced IDE, Floppy Connectors
D1
The mainboard features one 40-pin dual-channel IDE device connectors (IDE1)
providing support for up to two IDE devices, such as CD-ROM and Hard Disk
Drives (H.D.D.). This mainboard also includes one 34-pin floppy disk control-
ler (FDC) to accommodate the Floppy Disk Drive (FDD). Moreover, this
mainboard comes with one 80-pin ATA 133/100/66/33 ribbon cable to con-
nect to IDE H.D.D. and one 34-pin ribbon cable for F.D.D. connection.
Important : Ribbon cables are directional, therefore, make sure to al-
ways connect with the red cable stripe on the same side as pin #1 of the
IDE1 or FDC connector on the mainboard.

Serial ATA Connectors

D2
The Serial ATA is an enolutionary
replacement for the Parallel ATA
physical storge interface. Serial
ATA is scalable and will allow
future enhancements to the com-
puting platform. The Serial ATA
interface supports data transfer
rates up to 150MB/s.
1
1
- 34 -
IDE1
FLP1