Shuttle FN25 User Manual page 65

Serial-ATA 1/2
This item allows you to enable/disable the Serial-ATA 1/2.
Ø The choice: Enabled or Disabled.
SATA DMA transfer
This item allows you to enable/disable the SATA transfer access.
Ø The choice: Enabled or Disabled.
IDE Prefetch Mode
The onboard IDE drive interface support IDE prefetching for faster drive
access. If you install a primary and /or secondary add-on IDE interface,
set this field to Disabled if the interface does not support prefetching.
Ø The Choice: Enabled or Disabled.
IDE DMA transfer access
This item allows you to enable/disable the IDE DMA transfer access.
Ø The choice: Enabled or Disabled.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or mul-
tiple sector read/write. If your IDE hard drive supports block mode(most
new drivers do), select Enabled for automatic detection of the optimal
number of block read/write per sector the drive can support.
Ø The Choice: Enable or Disabled.
Onboard PCI Device
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
OnChip USB
This should be enabled if your system has a USB installed on the system
board and you want to use it.
Ø The choice: Desable, V1.1+V2.0 or V1.1.
OnChip Lan
This item allows you to control the onboard Lan.
Ø The Choice: AUTO or Disabled.
Onboard SuperIO Device
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
- 60 -