Saeco Phedra Evo D.A. 5P2015 Operation And Maintenance page 51

DISPLAY
1.13.
Water compensation
1.13.1.
Beans
1.14.
Lighting Type
1.15.
Grouping Powders
1.15.1.
Enable
1.15.2.
Grouping Powders
1.16.
Pre-grinding
yes
1.17.
Display settings
Water compensation for coffee beverages.
The exact quantity of water dispensed by each machine depends on the construction
tolerances of each water circuit component (pump, flowmeter, tubes, etc.).
This menu allows you to set a correction "evening out" these differences so that the end
result in the cup is always the same even if the machine is different.
During manufacturing, the optimum value is calculated and stored for each vending machine.
If a FACTORY DEFAULT is carried out or the CPU board is replaced, you need to reset
the correct value by following the simple instructions here below:
• Set the water for the COFFEE beverage = 30
• Dispense 3 beverages, checking their weight and calculating the rounded-up mean value
• If the result obtained is higher or lower than 30, the excess/default value must be
subtracted/added from/to the value set by default
EXAMPLE:
BEVERAGE 1 SEQUENCE 000C
COFFEE WATER = 30
Coffee 1 = 32 g
Coffee 2 = 35 g
Coffee 3 = 28 g
Work out the mean:
32 + 35 +28 = 95 -> 95/3 = 31.6
In this case, 31.6 being the obtained value, the machine is dispensing more water than the
set amount, so you will need to subtract 2 from the value set in the BEANS
COMPENSATION menu
If the mean value obtained were 28, you should add 2 to the value set in the BEANS
COMPENSATION menu
Allows you to select the water compensation for products made from coffee beans
It allows selecting the lighting mode of the dispensing outlet.
The options are:
Never, Always, beverage dispensing, beverage end.
It enables creating a group of 2 instant product containers.
The groups of containers can be used when a higher capacity of instant powder is required for a particular product
(e. g . when chocolate is largely used in a certain location, 2 chocolate powder containers can be dedicated
accordingly).
The machine software will be responsible for alternatively starting the two powder motors, to guarantee equal
product consumption in the 2 containers.
To use the instant product groups proceed as follows:
enter the System Management through the Groups option
enable groups management
select the pair of containers you would like to group together
programme the beverage recipe by introducing one of the 2 instant products that have been grouped.
Enables the instant product containers groups
Choosing the powder motor pair to be grouped together
Enables instant pre-grinding of the coffee dose.
Display settings
Description
English
51