Saeco Phedra Evo D.A. 5P2015 Operation And Maintenance page 49

DISPLAY
1.6.2.
Programmable
1.7.
Steam Cleaning
1.7.1.
Steam Cleaning Time
1.7.2.
Enable Capp. Clean.
1.8.
Preheating
00
1.8.1.
Coffee Preheat.
1.8.1.1.
Operation after(min)
1.8.1.2.
Extra Coffee Dose
1.8.2.
Cappuccino Preheat.
00
In case the steam circuit remains inactive for some hours (to be set under the option
"Steam Cleaning Time") the vending machine will not allow brewing any beverages with
steam (under the letter "S" in the product list) unless a cleaning cycle is activated.
The message "NO Cappuccino" will be displayed (by setting the number of hours to zero
the cleaning message and the stop status will be disabled).
The cycle can be activated in the "Maintenance" menu as well as during normal operation of
the machine through the user cycle.
Activation using the menu:
Select the option "Steam Cleaning" in the "Maintenance" menu.
Activation during normal operation:
The machine must comply with the following:
1 - Vending machine in its "Ready" status.
2 - No brewing in progress.
3 - Option "Enable Steam Wash" in the "System Management" menu enabled.
To activate the cycle simply press the buttons corresponding to beverages 4 and 8
simultaneously.
Cycle description:
The cycle operation is independent from the activation mode (no matter if started or not
from the "Maintenance" menu) and it consists of two phases: the "Wash Cycle" and "Rinse
Cycle".
During the first phase, a display message will request to pour the mix of water and cleaning
solution (about 400 gr of water and Saeco compound).
Simultaneously press the buttons corresponding to beverages 4 and 8 to start the "Wash
Cycle".
This phase will last 75 seconds, then the machine will pass to the following one.
During the second phase, a display message will request to insert only the water container
(about 400 gr of water).
Simultaneously press the buttons corresponding to beverages 4 and 8 to start the "Rinse
Cycle".
This cycle will last 75 seconds.
At the end of this procedure, the cleaning cycle will be considered as completed and the
Cappuccinatore as cleaned, thus enabling brewing beverages with milk.
It refers to the circuit of the Cappuccinatore: it allows setting the interval (in hours) after
which a cleaning cycle of the circuit is requested.
If set on YES, it allows starting the cleaning cycle by simultaneously pressing the two
beverage buttons 4 and 8.
This allows executing a cleaning cycle on the circuit of the Cappuccinatore without the need
to open the machine.
Allows setting timing and amounts for preheating and precooling for instant product circuits
and for the coffee brew group.
Settings for the preheating cycle of the brew group.
Time (expressed in minutes) of brew group inactivity after which the group starts
preheating.
By setting it to 0, the preheating is disabled.
Increase in the water dose (in ml) for the first coffee (by first coffee we understand the
coffee for which the preheating of the brew group is activated).
It refers to the circuit of the Cappuccinatore: it allows setting the minutes of inactivity after
which a preheating cycle is requested before dispensing steam (by setting this value to zero
the preheating cycle is disabled).
This cycle improves the operation of the Cappuccinatore after a long period of inactivity.
Description
English
49