Configuring Ports To Enable Webserver Functions - Honeywell CIPer 50 Installation & Commissioning Instructions

FINISHED!
Configuring Ports to Enable
Webserver Functions
The CIPer Model 50 controller provides webserver func-
tionality, e.g., for using the WEBs N4 Supervisor. In order to
use webserver functions, the http and https standard port
settings must be changed as follows:
• http standard port 80 to 8080
• https standard port 443 to 8443
After the changes are done, the controller is reachable via
both pairs of ports, i.e., via the old standard ports and via
the newly set ports.
Procedure
1. In the WEBs N4 Nav tree, expand the Services folder,
and then double-click WebService.
RESULT: The Property Sheet Sheet displays to the
right.
CIPer MODEL 50 CONTROLLER – INSTALLATION & COMMISSIONING INSTRUCTIONS
2. Expand the Http Port and Https Port options.
3. Change Http Port to 8080 and the Https Port to 8443.
4. Click the Save button at the bottom.
RESULT: The changed port settings are saved.
FINISHED!
13 31-00233EFS-01