Technical Data - Electrolux TK L2 E User Manual

Condenser dryer with drying rack
Hide thumbs Also See for TK L2 E:
Table of Contents

Advertisement

Available languages

Available languages

To high loading volume.
Laundry insufficiently spun.
Particularly high room temperature - no
machine fault.
1) In case of error message on the LCD (e.g. E51 - only dryers with the LCD): Switch the dryer off and on. Set
programme. Press the Start / Pause button. Does not work? - inform local service and quote the error code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaning chapter
4) see Machine settings chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Changing the bulb for interior lighting
Only use a special bulb which is designed specially
for dryers. The special bulb can be obtained from
your local service centre.
Important! When the appliance is switched on,
the interior lighting switches itself off after 4
minutes when the door is open.
Warning! Do not use standard bulbs! These
develop too much heat and may damage the
machine!
Before replacing the bulb, disconnect the mains
plug; with a permanent connection: fully unscrew
or deactivate the fuse.

Technical data

Parameter
Height x width x depth
Drum volume
Depth with loading door open
Height can be adjusted by
Weight when empty
Loading volume (depends on programme)
Voltage
Required fuse
Total power
Energy efficiency class
Energy consumption (7 kg of cotton, pre-drained
2)
at 1000 rpm)
Average annual energy consumption
Use
Permissible ambient temperature
The consumption values have been established under standard conditions. They may deviate when
1)
Consumption values
the machine is operated in domestic circumstances.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
1. Unscrew cover above the bulb (this can be
found directly behind the loading aperture, at
the top; refer to "Description of machine" sec-
tion.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket be-
fore screwing back the door light cover. Do not
operate the dryer when missing o-ring gasket on
door light cover.
Warning! For safety reasons, the cover must
be screwed down tightly. If this is not done,
the dryer must not be operated.
85 x 60 x 58 cm
108 l
109 cm
1.5 cm
approx. 40 kg
max. 7 kg
220-230 V
10 A
2350 W
B
3.92 kWh
284.1 kWh
Domestic
+ 5°C to + 35°C
electrolux 71
Value

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents