NETGEAR S350 Series User Manual page 202

S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Managed Pro Switches
• Drop. Select this radio button to require each inbound packet to be dropped.
• Mark VLAN CoS. Select this radio button to specify the VLAN priority, which you must
select from the menu. The VLAN priority is expressed as a value in the range from 0
to 7.
• Mark IP Precedence. Select this radio button to require packets to be marked with an
IP precedence value before being forwarded. You must select an IP precedence
value from 0 to 7 from the menu.
• Mirror. Select this radio button to require packets to be mirrored to an interface or
LAG, one of which you must select from the menu.
• Redirect. Select this radio button to require packets to be redirected to an interface or
LAG, one of which you must select from the menu.
• Mark IP DSCP. Select this radio button to require packet to be marked with an IP
DSCP keyword code, which you must select from the menu. The DSCP value is
defined as the high-order 6 bits of the Service Type octet in the IP header.
• Simple Policy. Select this radio button to define the traffic policing style for the class.
By default, this simple policy is color blind, and color classes do not apply. A simple
policy supports a single data rate and a single burst size and results in one of two
outcomes: conform or violate.
Specify a policy action for packets that conform or violate to the policy:
a. Committed Rate. Enter the committed rate that is applied to conforming packets
by specifying a value in the range from 1 to 4294967295 Kbps.
b. Committed Burst Size. Enter the committed burst size that is applied to
conforming packets by specifying a value in the range from 1 to 128 Kbps.
c. In the Conform Action section, select one of the following radio buttons:
• Send. Packets are forwarded unmodified. This is the default confirming action.
• Drop. Packets are dropped.
• Mark CoS. Packets are marked by DiffServ with the specified CoS value
before being forwarded. This selection requires that the Mark CoS field is set.
You must select a CoS value from 0 to 7 from the menu.
• Mark IP Precedence. These packets are marked by DiffServ with the specified
IP Precedence value before being forwarded. This selection requires that the
Mark IP Precedence field is set. You must select an IP precedence value from
0 to 7 from the menu.
• Mark IP DSCP. Packets are marked by DiffServ with the specified DSCP value
before being forwarded. This selection requires that the DSCP field is set. You
must either select a DSCP code from the menu or enter an IP DSCP value
from 0 to 63 in the field next to the menu. A value that you enter in the field
overrides any selection from the menu.
The DSCP value is defined as the high-order six bits of the Service Type octet
in the IP header.
Configure Quality of Service 202 User Manual