NETGEAR S350 Series User Manual page 115
24-port (poe+) and 48-port gigabit ethernet smart managed pro switches with 2 or 4 sfp ports
Hide thumbs
Also See for S350 Series:
- User manual (351 pages) ,
- Hardware installation manual (30 pages) ,
- Product setup sheet (4 pages)
Table of Contents
Advertisement
S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Managed Pro Switches
•
To configure all interfaces with the same settings, select the check box in the heading
row.
8. In the Description field, enter the description string to be attached to a port.
The string can be up to 64 characters in length.
9. From the Admin Mode menu, select Enable or Disable.
This selection specifies the administrative mode for port control. You must select Enable
in order for the port to participate in the network. The default is Enable.
10. From the Autonegotiation menu, select Enable or Disable.
This selection specifies the autonegotiation mode for the port. The default is Enable.
Note: After you change the autonegotiation mode, the switch might be
inaccessible for a number of seconds while the new settings take
effect.
11. In the Speed field, specify the speed value for the selected port.
Possible field values are as follows:
•
Auto. All supported speeds.
•
10. 10 Mbits/second
•
100. 100 Mbits/second
The delimiter characters for setting different speed values are a comma (,), a period (.)
and a space ( ). For you to set the autonegotiation speed, the autonegotiation mode must
be set to Enable. The default is Auto.
Note: After you change the speed value, the switch might be inaccessible for
a number of seconds while the new settings take effect.
12. From the Duplex Mode menu, select the duplex mode for the selected port.
The options are as follows:
•
Half. Indicates that the interface supports transmission between the devices in only
one direction at a time.
•
Full. Indicates that the interface supports transmission between the devices in both
directions simultaneously.
•
Auto. Indicates that speed is set by the auto-negotiation process.
The default is Auto.
Note: After you change the duplex mode, the switch might be inaccessible
for a number of seconds while the new settings take effect.
13. From the Link Trap menu, select whether or not to send a trap when the link status
changes.
By default, the switch sends a link trap.
Configure Switching
115
User Manual
Hide quick links:
Advertisement
Table of Contents
