Table of Contents
Advertisement
Position the plates on either side of the lift/lower cylinder rod and insert
the pin through the plates and cylinder rod. With the cylinder connected
to the inner draw latch plates, rotate the draw latch assembly toward
the draw latch mount holes on the A-frame. Align the holes in the outer
draw latch plate with those of the inner draw latch plates and the
A-frame. Note: The A-FRAME LATCH, located at the rear center of
the A-frame, should be raised up to insert the draw latch mount pin.
Pull the A-FRAME LATCH PULL PIN out and rotate the latch counter-
clockwise if it is locked into position. Secure the assembly to the A-frame
by replacing the draw latch mount pin and spacer. Reset the A-frame
latch so the A-frame latch pull pin locks into place.
Once you have completed the draw latch installation, proceed to assemble
the manifold. The manifold, pump and coil harness have been joined
together at the factory; however, the manifold contains several components
that you will need to install prior to securing the assembly to the A-frame.
9. Each of the 8 HOSE PORTS on the HYDRAULIC MANIFOLD are
covered with stretch wrap. Remove the wrap and install the appropriate
fitting (illustrated below) in its respective port.
Note: All ports are identified by a stamped number on the manifold.
The numbers also identify the hydraulic functions, which can be ref-
erenced on the label under the hydraulic pump and manifold cover
(see illustration on page 8).
Note: The gray arrows shown on the manifold illustration below
indicate the direction the 90˚ adapters should face to receive the
hydraulic hoses.
9/16"
9/16"
Male O.R.B. Connector Adapter
(Ports #3,4,8,9)
7/16"
9/16"
Male O.R.B. Connector Adapter
(Ports #7 & #10)
7
8
CV2
7/16"
90˚ Swivel Elbow
(Ports #7 & #10)
2
3
1
4
All of the hoses shipped with the snowplow con-
tain a printed label (with a part number) applied
to the hose. Install the following hoses to their
respective ports on the manifold:
Hose P/N 60223 Ports #1 & #2
Hose P/N 60273 Port #3
Hose P/N 60274 Port #4
Hose P/N 60019 Ports #7 & #10*
Hose P/N 60224 Ports #8 & #9*
Note: See diagram on page 8.
Installing The Manifold Adapters
There are a total of 18 hydraulic adapters to
install. All of the adapters can be found packaged
with the manifold assembly. Remove the protective
stretch wrap from the manifold in a clean area.
DO NOT let any foreign objects enter into the
open ports. The valves can become contaminated
and greatly hinder the plow's performance.
Review the table on page 20 for proper torque
specifications.
9/16"
90˚ Swivel Elbow
(Ports #3,4,8,9)
10
9
CV4
Moldboard & A-frame Assembly (continued)
Printed
Label
9/16"
9/16"
Adjustable Elbow
O.R.B. Adapter (Port #2)
9/16"
Male Extra Long
Elbow Adapter
(Port #1)
9/16"
07
Hide quick links:
Advertisement
Table of Contents
